DIY Temporary Tattoo II

DIY Temporary Tattoo II


****** BODY ART TRANSFER KIT ****** Print image in revese format in laser printer or copier on our image transfer sheet, and trim it Apply our body glue on the image and heat it with hair dryer for about 20 to 30 seconds. Peel off the releasing film to the image from the edge and cut it. Position the tattoo image onto skin. Peel off the backing paper from the peeled edge and leave a film(the releasing film) covering the tattoo image on the skin. Use water ( or a damp cloth as shown) to dissolve the film (the releasing film). Dry it with a semi-wet cloth. Apply a thin layer of baby powder on tattoo image Use a damp cloth to clean the baby powder mark.

2 thoughts on “DIY Temporary Tattoo II

  1. We sell this image transfer kit on Ebay:
    http://www.ebay.com/sch/onedecals/m.html?item=282020558914&ssPageName=STRK%3AMESELX%3AIT&rt=nc&_trksid=p2047675.l2562

Leave a Reply

Your email address will not be published. Required fields are marked *